Tender Details

Country: USA
Summary: Purchase of Two (2) 2 Ton Electrical Hoist and Trolley that includes installation
UST Ref No: 118543663
Deadline: 07 May 2025
Financier: Self Financed
Purchaser Ownership: Government
Tender Value: Refer Document
Notice Type: Tender
Document Ref. No.: FA301625S6102
Purchaser's Detail:
Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details.
Login to see details
Description:
Description
1.1 PROJECT SCOPE: The contractor shall purchase and install two 2-ton electrical hoists in hangar 4 on Joint Base San Antonio - Randolph using existing hoist railing at a height of 20 feet on both the east and west end of the hangar.
1.2 PROJECT DESCRIPTION:
1.2.1 The contractor will remove any obstructions to the rail system that would prevent its use when the hoists are installed.
1.2.2 The hoist must be able to traverse the 20-foot section at each respective ends of the northwest rail and southeast rail. The rail-s bottom flange is 5 inches wide.
1.2.3 Contractors shall purchase two 2-ton rated electrical hoists and install them on hoist rail system that is certified to 7,000 lbs. One hoist will be installed on the east rail system and one hoist will be installed on the west rail system.
1.2.4 Each hoist must have a wired pendant control box that is connected directly to the hoist and that is sufficient in length so that the user can operate the hoist at least 10- away from the moving aircraft engine.
1.2.5 The contractor shall install ANSI, ASME and OSHA Standard markings as required and stencil rail to correct certified weight of 7000 lbs.
1.2.6 Hoist electrical requirements are 220-480 volts depending on the type of hoist that is installed, as long as it has a 2-ton capacity, three phases, and dual speed. The total weight of the hoist shall not exceed 500 lbs.
1.2.7 Load certification is available and current.
1.2.8 Contractors will need to provide electricity to the hoist. Electricity will be provided using an in-line retractable power cord reel or tagline. Electrical power will not need to cover the entire length of the rail, only 25-30 ft from the end of the rail. The voltage range must be within 220-480 volts. This distance does not account for any additional cabling needed to run the system.
1.2.9 The hoist and trolley motions will be motorized. There is no existing trolley installed on the current ...
Documents:

SOURCES-SOUGHT-2-Ton-Electrical-Hoist-and-Trolle.pdf

If you are registered member, kindly login to view full details of this tender notice:

Purchase of Two (2) 2 Ton Electrical Hoist and Trolley that includes installation - USA Tender

The DEPT OF DEFENSE | DEPT OF THE AIR FORCE, a Government sector organization in USA, has announced a new tender for Purchase of Two (2) 2 Ton Electrical Hoist and Trolley that includes installation. This tender is published on USARFP under UST Ref No: 118543663 and is categorized as a Tender. Interested and eligible suppliers are invited to participate by reviewing the tender documents and submitting their bids before the deadline on 2025-05-07.

The estimated tender value is Refer Document, and full details, including technical specifications and submission requirements, are provided in the official tender documents. Ensure all submissions meet the criteria outlined to be considered for evaluation.