100% Secure Payments
Tender Details
- Country: USA
- Summary: Sanding Booth System
- UST Ref No: 124595950
- Deadline: 22 Aug 2025
- Competition: ICB
- Financier: Self Financed
- Purchaser Ownership: Public
- Tender Value: Refer Document
- Notice Type: Tender
- Document Ref. No.: W911S225U1611
- Purchaser's Detail :
- Description :
- Description
Purchase Description for a Sanding BoothScopeThe following document provides the requirements and specifications for the sanding booth.Applicable Documents1. Standards and Regulations:a. NFPA 33b. OSHA CFR-29.1910.1072. Additional DocumentsRequirements3. General RequirementsThis section provides the design specification requirements for the sanding booth.a. Two stage filtration to capture sanding booth dustb. Must accommodate a monorail fed down the middle of the working area4. Specific RequirementsThis section provides specific requirements for the sanding booth equipment requested.a. Inside working dimensionsi. 7 ft. W x 9 ft. 6 in. H x 36 in. D front and back booth section separated by a 5 in. overhead gap for the monorail fed item to be sanding1. Entrance and exit of booth with be notched out to make an overall opening of 25 in. W x 106 in. Tii. 7 ft. 4 in. W x 10 ft. 2 in. H x 12 ft. 2 in. D overall outside dimensions to include the 2-stage filtration and exhaust plenumb. Constructioni. 18g reinforced steel panels1. Pre-punched on 6 in. centers for nut/bolt construction2. Equipped with galvanized companion flanges for rust resistancec. Lightingi. Two 4,000 lumen light fixtures1. Sealed/gasketed2. High efficiency LEDd. Exhaust filtrationi. First stage1. Blanket style poly roll media with Filterloc management system with complete locking frame to hold media in place without gaps or leaksii. Second stage1. Pocket/bag filtersiii. On board manometer1. Displays air resistance across filter systeme. Exhaust fani. 36 in. diameter tube-axial duct fanii. Spark resistant fan bladesiii. Rated at 15,525 CFM at 1.25 in. static, 10 HPiv. Belt driven with motor pulley, fan-pulley, v-belts, motor base, lubricated sealed bearingsv. Thermal resetsf. Exhaust stacki. Fan connector ring to connect fan to boothii. Section of stack above fan equipped with inspection plateiii. 90 deg elbowiv. Section of stack for horizontal flowv. Exterior wall mount louvered damper ass... - Documents :
Purchaser : DEPT OF DEFENSE | DEPT OF THE ARMY
MICC FORT DRUM 4205 PO VALLEY RD, FORT DRUM , NY 13602-5220, USA
Primary Point of Contact: David Fortune, david.c.fortune.civ@army.mil, Phone Number 9184206445
Email :david.c.fortune.civ@army.mil
If you are registered member, kindly login to view full details of this tender notice:
CLICK HERE TO LOGIN
