- Country: USA
- Summary: Sources Sought Notice for Bond StrengthTester
- UST Ref No: 114694128
- Deadline: 26 Feb 2025
- Financier: Self Financed
- Purchaser Ownership: Government
- Tender Value: Refer Document
- Notice Type: Tender
- Document Ref. No.: NIST-SS25-17
- Purchaser's Detail:Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details. Login to see full purchaser details.
- Description:
- Description
The National Institute of Standards and Technology (NIST), Physical Measurement Laboratory, Quantum Sensors Division, Device Fabrication Group (DFG) has a sub-program to develop bond strength measurements and bond strength standards for dielectric, metal to metal, and hybrid bonding. As part of this program, the DFG intends to acquire and demonstrate the use of a commercial bond tester for these measurements and potential standards. The available lab spaces necessitate the acquisition of a bench top unit which can operate with minimal utility requirements. We micro-fabricate our own bond test structures than can be tested in shear or pull test mode depending on the fixturing. We will require the ability to design, produce, and install custom fixturing as we survey the possible measurement types.
NIST is seeking information from sources that may be capable of providing a solution that will achieve the objectives described above that meets or exceeds the following draft minimum specifications:
1. Physical- Characteristics
Size Envelope of 32 inches (in) by 32 inches (in) by 32 inches (in) or lower. Weight of 200 pounds (lb) or lower.2. Utility Requirements
Able to operate with a 120 Volt (V) single phase 60 hertz (Hz) 20 Amp (A) circuit Able to operate with a clean dry air source of 75 pounds per inch (psi). Able to operate with vacuum supply of 20 inch mercury (20 in Hg)3. Stage and Head Motion
Minimum: X-Y range of 100 mm - 100 mm. Minimum: Z range of 40 mm. Minimum: X-Y-Z resolution 1 micro-meter. Motorized X-Y-Z with joystick or computer control.4. Testing Type, Force, and Accuracy
Wire Pull, 100 gram-Force (g-F), better than 1% accuracy. Pull, 10 kilogram-Force (kg-F), better than 1% accuracy. Die Shear, 10 kilogram-Force (kg-F), better than 1% accuracy. Die Shear, 100 kilogram-Force (kg-F), better than 1% accuracy. Stud Pull, 100 kilogram-Force (kg-F), better than 1% accuracy.5. Device Under Test Fixturing
Configu... - Documents:
If you are registered member, kindly login to view full details of this tender notice:
CLICK HERE TO LOGINSources Sought Notice for Bond StrengthTester - USA Tender
The COMMERCE, DEPARTMENT OF | NATIONAL INSTITUTE OF STANDARDS AND TECHNOLOGY, a Government sector organization in USA, has announced a new tender for Sources Sought Notice for Bond StrengthTester. This tender is published on USARFP under UST Ref No: 114694128 and is categorized as a Tender. Interested and eligible suppliers are invited to participate by reviewing the tender documents and submitting their bids before the deadline on 2025-02-26.
The estimated tender value is Refer Document, and full details, including technical specifications and submission requirements, are provided in the official tender documents. Ensure all submissions meet the criteria outlined to be considered for evaluation.
